Decal Application / Removal
Clean the area thoroughly with rubbing alcohol or soap and water. DO NOT use cleaning products such as Windex. These will leave a residue behind that will prevent the sticker from adhering to the surface firmly.
Prepare the sticker for application by firmly rubbing a squeegee or credit card across the front of the decal. This removes any air bubbles that may have formed during shipping.
Peel the white paper backing off the sticker. If the sticker stays on the backing, slowly replace the backing and repeat Step 2.
Lower the sticker onto the surface slowly and rub it in place firmly with a squeegee (or credit card). For best results, wait 24 hours before moving to the next step.
Slowly peel the clear transfer tape off at an angle. If sticker wants to pull away from the surface, repeat Step 4.
Use a pin to poke any air bubbles in the center and push the air out through the hole. For best results do not apply a sticker in extreme hot or cold temperatures.
Heat the area where the sticker is with a blow dryer and just peel the sticker back off.
If needed, clean any residue left behind with a window cleaner. If the sticker was on the car paint then just buff the area with car wax.
Once the decal is removed, it cannot be reapplied.